Table des Matières
Publicité
+
+
Motor Shaft
Arbre d'entraînement
du moteur
Eje del motor
+
+
Groove
Ranura
Ouverture
Replacing Belt
+
Lift Agitator Up
Unidad del agitador
Soulever l'agitateur
+
End Cap
Tapa del extremo
Bouchon
➢ ➢ Replace belt whenever a burning
rubber smell caused by excessive
slippage occurs.
➢ ➢ Remove lower plate.
➢ ➢ Remove agitator by carefully lifting
out.
➢ ➢ Remove worn or broken belt.
➢ ➢ Clean agitator.
➢ ➢ Loop new belt (Panasonic Type UB8
only) around motor shaft and agitator
pulley; see illustration for correct belt
routing.
➢ ➢ Reinstall agitator back into nozzle
housing grooves.
➢ ➢ After reinstalling the agitator, turn it
by hand to make sure that belt is not
twisted or pinched and that all
rotating parts turn freely.
➢ ➢ Reinstall lower plate.
- 30 -
Publicité
Table des Matières
