Sylvania ValueLED 3A Mode D'emploi page 5

Mounting with Wall Mount:
• For Wall mounting (remove parts 2 and 6 from figure 1)
a. Remove and discard bolts (part 8 from figure 1) and remove rubber plugs (part 14 from figure 1).
b. Place the rubber plugs (part 14) where the discarded bolts were previously located (see figure 4)
c. Secure the bracket to the wall with bolts (part 9).
d. Remove the screws for the junction box cover (part 3 of figure 1). Pull the supply wire into the bracket's
junction box.
e. Make all wiring connections via the supplied wire leads in accordance with NEC and local codes and pull the
wires completely into bracket's junction box and making appropriate electrical connections.
f. Re-install the junction box cover plate and secure with the previously removed screws (Figure 8).
g. The angle of the mounting can be adjusted by loosening the locking bolt and aiming the luminaire.
h. Tighten the locking bolt once the desired angle is reached.
Pole Mount Bolt Drill Pattern
3983099