Using
•
We recommend you use it when your pores are enlarged such as after
taking a bath, etc.
•
Cleansing two or three times a week is recommended.
1. Remove any make-up from your face, leaving your skin bare.
•
Never use the appliance on skin coated with cleansing lotion or facial
soap.
2. Remove the cap and pour tap water into the water tank.
3. Slide the power switch to "1".
•
The mist nozzle will produce a fine spray of water.
4. Move the appliance slowly around the tip of
your nose.
•
Roughly cleanse the entire surface of your
nose without focusing on any one spot.
•
If you apply the nozzle directly on to your
skin to improve adhesion, the mist will
automatically stop.
5. Move the appliance over your nose in the
direction of the arrows.
6. Rinse your face, and keep your face sufficiently moisturized using
moisturizing lotion or any other skin conditioner you normally use.
Around the tip and wings of nose
1. Move the appliance all over your nose for 1 minute.
2. Move it over the wings of your nostrils for 2 minutes.
(Do not repeatedly move it over the wings of your nostrils where the skin is
sensitive.)
When mist is not released
1. Turn the power switch off and remove the cap, then
insert the pointed end of the cleaning tool or a
cotton swab into the mist nozzle a few times.
2. Pour tap water into the water tank.
3. Turn the power switch on and block the mist nozzle for approximately
10 seconds (while checking to see if the water in the tank is bubbling).
4. Drain the water out of the water tank.
4
Using your pore cleanser