Publicité
Les langues disponibles
Les langues disponibles
The Vega self-aligning photocell is a safety device comprising modulated infrared Transmitter and Receiver. Breaking the path
of the beam causes a switch in the status of the electric contact on the Receiver.
Power supply 24V
Absorbtion Tx=20mA Rx=30mA
Sensing range 20m
IP 54
Obstacle detection time 13mSec
In order to ensure personal safety, it is important that all instructions be carried out to the letter. Incorrect installation or
use of product could cause serious personal injury.
Before attempting installation, read the instructions carefully and store in a safe place for future reference.
In order to ensure optimum working efficiency, the Receiver and Transmitter should be properly aligned.
Due to the self-alignment feature, it is not possible to install two pairs of VEGA on the same system. In such cases ORION
should be used.
Two types of installation are possible:
Wall with embedded tube (fig.1).
1.
2.
With outer tube/sheath (fig.2).
•
Carry out the work necessary for the electrical connections.
•
Fix the Vega enclosures using suitable screws and screw anchors.
•
Effect the electrical connections on terminal blocks of Receiver (fig.4) and Transmitter (fig.5) using the cable duct sup-
plied.
•
Connect wiring to the electronic control unit and any other photocells present in the system.
•
Refer to the diagrams contained in the electronic control unit instructions for details of the various configurations.
•
Power up photocells and check that LED DL1 on the Receiver (fig.4) and Transmitter (fig.5) is lit.
•
Assemble Vega using the components supplied (fig.6).
•
Ensure correct alignment by checking against the light that LED DL2 on the Receiver (fig. 4) is also lit.
Manufacturer:
GENIUS S.p.A.
Address:
Via Padre Elzi, 32 - 24050 - Grassobbio- Bergamo - ITALY
Declares that:
The active optoelectronic safety device model VEGA
•
conforms to the essential safety requirements of the following EEC directives:
•
2006/95/EC Low Voltage directive.
•
2004/108/EC Electromagnetic Compatibility directive.
Additional information:
This product underwent a test in a typical uniform configuration (all products manufactured by GENIUS S.p.A.).
Grassobbio, September 16, 2010
/ 24V~
2. ELECTRICAL CONNECTIONS
CE DECLARATION OF CONFORMITY
Contact type and rating NC
Type of alignment automatic
Self-alignment angle
Operating ambient tem-
perature
Installation wall-mounting
1. FITTING
3. START-UP
VEGA
Pagina 3
Guide for the installer
60VA / 24W
+/- 7° (20 m)
+/- 13,5° (5 m)
-20°C
+55°C
Managing Director
D. Gianantoni
Publicité
