Uberhaus Design 38115071 Guide De L'utilisateur page 10

Fig.16: Settle back card slot 1 (J1) and back card slot 2 (J2) to edge beam and middle beam, and secure one side of
back card slot to edge beam by using bolt (HH) and flat washer (BB).
Fig.16-1: Use bolt (CC) and flat washer (BB) to secure the back card slot 1(J1) and back card slot 2(J2) to the middle
beam ( L3 )
Fig.17: Set the side card slot 1 (N1) and side card slot 2 (N2) to side PC panel, and secure them with bolt HH and flat
washer BB.
Fig.18: Insert the PC panel 1(M1) into the slot of middle beam (L3), install the edge beam 1(L1) and edge beam 2(L2)
Fig.18-1: Insert the PC panel (N) into the slot of middle beam (L3), install the edge beam1 (L1) and edge beam2 (L2) the
same way.
Fig.18-2: Insert PC panel 1(M1) into the bottom card slot of middle beam (L3), install edge beam 1(L1) and edge beam
2(L2) the same way.
Fig.19: Insert the bolt (JJ) into the bottom card slot of middle beam (L3), edge beam 1 (L1) and edge beam 2 (L2), then set
the front card slot 1 (K1) to complete bolt (JJ) and insert the front card slot into the PC panel. Install front card slot 2(K2)
the same way, see step 3.
Fig.20: Install the blank 2(T2) to edge beam 2(L2) and front card slot 2(K2), and secure them with bolt DD and flat
washer BB. Same way to install the blank 1(T1) and blank 3(T3), see step 3.
Hardware Pack 4
KK
Hardware Pack 5
PDF 文件使用 "pdfFactory Pro" 试用版本创建
50MM
Screw M6*80
LL
EE Plastic ring
14 PCS
8PCS
76PCS
www.fineprint.cn