Sauder Carson Forge 419082 Mode D'emploi page 21

Commode
Table des Matières

Publicité

Step 16
Carefully stand your unit upright.
å
We recommend using the SAFETY BRACKET (1G) for added stability.
å
Use a BLACK 9/16" LARGE HEAD SCREW (1S) into the top of the unit
and a BLACK 1-7/8" FLAT HEAD SCREW (2S) into a stud in your wall.
To insert the drawers into your unit, tip the fronts of the drawers down
å
and drop the glides on the drawers behind the glides on the unit. Lift
the fronts of the drawers up and slide them into the unit.
Apply the WARNING LABEL (5L) to the upper SMALL DRAWER
å
LEFT SIDE (D13). You should be able to read the label when
the drawer is open. When the drawer is closed, it will hide the label.
Peel off the backing and apply the label as shown in the diagram.
NOTE: This is a permanent label intended to last for the life of the
å
product. Once applied, do not try to remove it.
5L
D13
35 lbs.
35 lbs.
www.sauder.com/services
40 lbs.
30 lbs.
L
K
N
M
Serious or fatal crushing injuries can
occur from furniture tip-over. To help
prevent tip-over:
-Place heaviest items in the lowest drawers.
-Unless specifi cally designed to accommodate,
do not set TVs or other heavy objects on top of
this product.
-Never allow children to climb or hang on
drawers, doors, or shelves.
-Never open more than one drawer at a time.
-If equipped with a drawer interlock system, do not
defeat or remove it.
Use of tip-over restraints may only reduce,
but not eliminate, the risk of tip-over.
BLACK 1-7/8" FLAT HEAD SCREW
1G
BLACK 9/16" LARGE HEAD SCREW
(1 used into the top of your unit)
30 lbs.
35 lbs.
35 lbs.
419082
WARNING
(1 used into a stud in your wall)
2S
1S
Page 21

Publicité

Table des Matières
loading

Table des Matières