Publicité
Step 10
Carefully turn your unit over onto its front edges. Unfold the
å
BACK (F) and lay it over your unit.
Make equal margins along the two short edges and along the
å
two long edges of the BACK (F). Push on opposite corners of
your unit if needed to make it "square".
Fasten the BACK (F) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over
å
the UPRIGHT (C).
NOTE: The cut out squares must be toward the TOP (D).
å
www.sauder.com/services
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
These holes must line up
over the UPRIGHT (C).
F
419082
Caution
NAIL
(48 used in this step)
Cut-out square
D
1N
Page 15
Publicité
