Publicité
Les langues disponibles
Les langues disponibles
Dear Clients,
The TESY team would like to congratulate you on your new
purchase. We hope that your new appliance shall bring
more comfort to your home.
This technical description and instructions manual was
prepared in order to acquaint you with the product
and the conditions of proper installation and use. These
instructions were also intended for use by quali ed
technicians, who shall perform the initial installation, or
disassembly and repairs in the event of a breakdown.
The observance of the instructions contained herein is
in the interest of the buyer and represents one of the
warranty conditions, outlined in the warranty card.
Please consider that following the current instructions
will primarily be of interest to the consumer, but along
with this, it is also one of the warranty conditions, pointed
out in the warranty card, so that the consumer can
bene t from the free warranty services. The producer is
not responsible for damages in the appliance that have
appeared as a result of operation and/or installation not
corresponding to the instructions here.
The electric water heater complies with the requirements
of EN 60335-1, EN 60335-2-21.
I.
PURPOSE OF USE
The appliance is designed to supply hot water to
household facilities equipped with a piping system
operating with pressure not greater than 6 bars (0,6 Mpa).
IMPORTANT RULES
III.
•
The water heater must only be mounted in premises with normal re
resistance.
•
Do not switch on the water heater unless you established it was lled
with water.
Attention! Improper installation and connection of the appliance may make it
hazardous for the health and life of consumers. It may cause grievous and
permanent consequences, including but not limited to physical injuries and/or death.
Improper installation and connection of the appliance may also lead to damage to
the consumers' property /damage and/ or destruction/, or to that of third persons, as
a result of, but not limited to ooding, explosion and/or re.
Installation, connection to the main water and power supply, and putting into
operation must be carried out by certi ed electricians and technical personnel
certi ed in installation of this category of appliances, who have obtained their
license in the state where the installation and commissioning of the appliance are
carried out, and in compliance with its local legislation.
•
Upon connecting the water heater to the electric mains care must be
taken to connect the safety lead (for models without power cord with
plug).
•
If the water-heater will not be used for a longer period of time (more
than 3 days) and the temperature in the premise could drop below 0°C,
the water in the water-heater must be drained (observe the procedure
outlined in subsection 2 "Water heater's piping connection" of s. IV), to
avoid any possible damage of the appliance.
English
It is designed to operate only in closed and heated
premises where the temperature is not lower than 4°C and
it is not designed to operate in a continuous protracted
regime.
II.
TECHNICAL SPECIFICATIONS
1.
Nominal volume V, liters - see the appliance's rating plate
2.
Nominal voltage - see the appliance's rating plate
3.
Nominal power consumption - see the appliance's
rating plate
4.
Nominal pressure - see the appliance's rating plate
ATTENTION! This is not the water mains pressure. This
is the pressure that is announced for the appliance and
refers to the requirements of the safety standards.
5.
Water heater type - closed accumulating water heater,
with thermal insulation
6.
Inner coating: GC-glass-ceramics
7.
Daily energy consumption – see Annex I
8.
Rated load pro le - see Annex I
9.
Quantity of mixed water at 40°C V40 litres - see Annex I
10.
Maximum temperature of the thermostat - see Annex I
11.
Default temperature settings - see Annex I
12.
Energy e ciency during water heating - see Annex I
Instructions for use and maintenance
EN
7
Publicité
