Periods Of Inactivity; Extraordinary Maintenance; Important; Scrapping - IPC HPS Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

TABLE OF ROUTINE MAINTENANCE TO BE PER-

FORMED BY THE USER

Description of operations:

Check power cable - pipes - high pressure

connectors

Ist oil change in H.P. pump

Subsequent changes in H.P. pump

Change and clean fuel filters

Clean fuel tank

Clean water filter

These intervals refer to normal working conditions. For heavy duty use decrease the interval for each job.

For maintenance and/or repairs, use only original spare parts which offer the greatest characteristics of quality and

reliability. Failure to use original spare parts absolves the manufacturer from all liability and transfers it to the

If the machine is to remain inactive for a long period, disconnect the supply sources, drain the tank(s) of all the operating fluids

and protect any parts that could be damaged by the accumulation of dust.

Grease the parts that could be damaged by drying out, such as the supply hoses. When bringing back into use, ensure that

there are no cracks or cuts in the water supply hoses.

Oil and chemical products must be disposed of according to current legislation.

If you decide that the cleaner is no longer to be used, render it inoperative by removing the electric power cable. Ensure that all

parts of the cleaner that could be a source of danger are made harmless, especially for children who might use the old cleaner

for play. As the cleaner is considered special waste, dismantle it and divide the material according to type, then dispose of them

as required by the legislation in force.

Do not use parts dismantled for scrap as spare parts.

English

TABLE OF

BE PERFORMED BY THE TECHNICAL SERVICE

CENTRE

Descrizione operazioni:

Boiler:

Clean Coil

Each use

Descale coil

Clean fuel pump

After 50 hours

Change fuel nozzle

Every 500 hours

Regulade electrodes

Change electrodes

Every 100 hours

Change seals on H.P. pump

Every 50 hours

Change lanze nozzle

Calibrate and check the safety devices

IMPORTANT:

person carrying out the operation.