Busch-Jaeger 6550 Mode D'emploi page 37

Installation
The memory control unit 6550U-10x cannot be illuminated
if it is used in combination with the control element 6543-
xxx. In order to prevent any mistakes or error, please
remove the lighting element from the control element.
Slide Switch (see Fig. 1)
Applies only to 6550U-10x
Two different modes of operation are possible with the
Memory Pushbutton Controller (see also chapter
"Operation").
– Normal mode = Position below I ("as supplied" status).
– Pushbutton operation = Position above II
If necessary, change the slide switch position before
clipping on the Operating Element.
ENG 37