Sauder HomePlus 411802 Mode D'emploi page 11

Step Step 6
Slide the FEET (EE and FF) into the notches in
å
the SKIRTS (J and K).
Use a hammer to drive a PROPEL NUT (DD) into
å
the holes in the FEET (EE and FF). Now, turn an
ADJUSTABLE GLIDE (CC) into each PROPEL
NUT as shown in the upper diagram.
Fasten the SKIRTS (J and K) to the BOTTOM (D2).
å
Use four BLACK 9/16" WAFER HEAD
SCREWS (RR) through the FEET and into the
BOTTOM as shown in the lower diagram.
NOTE: To raise a corner of the unit, turn the
å
ADJUSTABLE GLIDE counter-clockwise. To lower
a corner, turn the ADJUSTABLE GLIDE clockwise.
K
BLACK 9/16" WAFER HEAD SCREW
(4 used in this step)
www.sauder.com/services
D2
J
K
RR
CC
(4 used)
DD
FF
Insert the ADJUSTABLE
SHELF (I) between the
ENDS (A and B) before
turning over the unit.
B
I
411802
EE
K
J
FF
A
EE
K
Page 11