General Instructions; Sensor Installation - Pro-User PDC2 Mode D'emploi

INSTALLATION
These instructions do not apply to all vehicles. They are only meant as a general
guide due to the number of different makes & models. For vehicle specific
questions contact your vehicle's manufacturer.

GENERAL INSTRUCTIONS

• The device must only be used by persons who have fully read and understood this
user's manual and have familiarized themselves with the device.
• Never rely solely to the PDC2 system while driving in reverse. The PDC2 is intended
only as an additional aid.
• Do not attach the sensors to the front of your vehicle.
• Do not cover any signal lamps with the sensors.
• Observe the applicable legal regulations of your country.
• Not suitable for vehicles with rear engines.
• Do not use in a vehicle that has a horn or alarm for reverse driving.
• Do not lengthen or shorten the cables.
• Do not paint or spray the sensors.
• Install horizontally.
• A false reaction can be registered if a DC to AC current inverter is being used nearby.
• The system uses the reverse lights of the bike carrier. This only works with 13-pin
trailer connectors of Jaeger type

SENSOR INSTALLATION

There are several ways to mount the sensors on the back of your vehicle (car, trailer,
caravan or bike carrier). But the most convenient is to mount it near the license plate or
rear lights (bike carrier). Supplied are two mounting plates that can be fixed behind the
license plate/rear light. The sensors itself can be fixed on the mounting plate, but also
directly fitted on a surface by the supplied double sided tape and screws. In some types
of vehicles (e.g. car, trailer, caravan or bike carrier) it might be not possible to mount
the sensors near the license plate or rear light. You may have to find another spot to
mount the sensors.
Installation examples:
4