Technical Specifications - miniland baby digimonitor 1.8 Mode D'emploi

ENGLISH
Problem
Interference or poor
reception
You cannot charge the
battery in the parent unit
If the Baby Unit has lost
its link with the Parent Unit

8. TECHNICAL SPECIFICATIONS

Frequency
Operating Range
Nº of configurable channels
Power (parent unit)
Rechargeable battery for monitor
Power (baby unit)
Operating time with battery fully charged (parent
unit)
LCD Screen size
9. PRODUCT DISPOSAL INFORMATION
· Remember to dispose of the product responsibly.
· Do not mix products bearing the crossed -out bin symbol with your general household waste.
· For the correct collection and treatment of these products take them to the collection points
designated by your local authority.
Alternatively contact the retailer who sold you the product.
Hereby, Miniland S.A. declares that this 89178 digimonitor 1.8" is in compliance with the
essential requirements and other relevant provisions of Directive 2014/53/UE.
Possible Cause
Other electronic devices may be
interfering with the signal
The camera and monitor may be
too far apart
The battery power may be too low
The camera or monitor may be
placed too close to many metal
objects
The AC/DC adapter is not plugged
in
The camera and monitor may be
too far apart
The link between both units has
been lost momentarily
The link between bothunits has
been lost
Solution
Move them away from the device
Move the monitor closer to the camera
Plug in the power adapter
Move them away from the device
Plug in the adapter
Move the monitor closer to the camera
Reset the units by disconnecting them
from the electrical power. Wait about 15
seconds before reconnecting. Allow up to
one minute for the Baby Unit and the Parent
Unit to synchronize.
Pair the camera and monitor again. See
5.2.8.5.
2.4GHz FHSS
250m (straight line and open space)
4
Input: 100-240VAC 50/60Hz Output: 5V 800mA
3.7V 900 mAh
Input: 100-240 VCA 50/60Hz Output: 5V 800mA
Approximately 5 hours
1.77''
16