miniland baby digimonitor 1.8 Mode D'emploi page 15

connected. Should this be the case, repeat the process explained above to connect the camera with the monitor
again.
Note 1: Before starting the pairing process, make sure that the camera and the monitor are close to each other.
Note 2: Each camera can be linked just with one monitor at a time.
Nota 3: If the monitor and the camera, for some reason, have left the factory without being paired, you will have
to do it manually adding the camera to channel 2, 3 or 4. You won't be able to pair the camera again with channel
1 until you have paired it in another channel and remove the channel 1 camera.
5.2.8.6. DELETE CAMERA
To delete one of the cameras connected, follow the next steps:
1. Press the MENU/Back
2. Press UP key or DOWN
sub-menu.
3. Press UP /DOWN
4. Press UP /DOWN
Note 1: If you only have one camera paired to the monitor, you won't be able to remove it.
Note 2: A channel needs to be deleted before pairing to a new camera unit.
6. MAINTENANCE
· Clean the surfaces of the camera and monitor with a soft, lint-free cloth.
· If the units become dirty, use a lightly dampened cloth to wipe surfaces, taking care to not allow water into any
openings.
· Never use cleaning agents or solvents.
7. TROUBLESHOOTING
Problem
No reception on
monitor
Only black and
images are displayed
The camera does not
transmit
You cannot hear the baby
on the parent unit
key and the menu icon will pop up.
key to select DELETE camera icon
key to select the desired camera to delete and press the
key to select BACK
Possible Cause
the Camera not turned on
Monitor not turned on
Camera: not plugged in to the
power adapter
Monitor: The power adapter is not
plugged
Monitor out or range
Connection lost
monitor and a camera already
linked
A wrong camera has been selected Change the camera number you are
white Check whether the camera is in
night vision/infrared mode
The camera is not turned on
Camera: the power adapter is not
plugged in
VOX mode or Standby mode are
active
The volume setting of the parent
unit is too low
icon or DELETE icon then press
Solution
Press and hold down button (III) for 2
seconds
Press and hold down the Power button (10)
Plug in the power adapter
Plug in the power adapter
Move the monitor closer to the camera
between the Link the camera with the monitor again. See
5.2.8.5.
watching. See 5.2.8.4.1.
In order to view the images in colour,
increase the level of light in the room the
camera is in or check there is nothing
covering the camera´s light sensor (II).
Press and hold down button (III) for 2
seconds
Plug in the power adapter
To see the monitored area continuously,
disconnect the VOX or Standby mode on
the Monitor
Set the volumen to the highest level
15
ENGLISH
then press key enter into the
key.
key.