Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. Press the programming button on the battery module
for 3 seconds, until the yellow LED on the up arrow turns
on and immediately off;
4. Within 20 seconds hook the battery module onto the
base plate to be memorized;
5. Wait 10 seconds, until the yellow LED on the up arrow
turns on and starts flashing quickly;
6. Within 10 seconds send the cancellation command of
the desired channel by pressing the up and down push
buttons simultaneously on the remote control, until the
LEDs on the battery module flash green quickly: the
chosen channel has been deleted.
Deleting all channels
1. Detach the battery module from its base plate;
2. Press the programming button on the battery module
for 3 seconds, until the yellow LED on the up arrow turns
on and immediately off;
3. Within 20 seconds hook the battery module onto the
base plate to be memorized;
4. The yellow LED on the up arrow will turn on and then
start flashing quickly. Wait 10 seconds until it flashes
more slowly;
5. Within 10 seconds send the cancellation command of
all channels by pressing the up and down push buttons
simultaneously on any remote control (set on any
channel), until the purple LED on the battery module
starts flashing: all channels have been deleted.
NOTE: the procedure can be suspended anytime by
pressing again the programming button of the battery
module.
For further instructions on using the remote control, refer
to the dedicated instruction manual.
RESTARTING THE BATTERY MODULE
If the battery module is not working properly, it is possible
to restart it by following the procedure described below:
1. Detach the battery module from its base plate;
2. Plug the battery charger into a power socket;
3. Plug the micro-USB connector into the port provided on
the battery module;
4. Pull out the connector.
14
Publicité
Table des Matières
