Axis Communications Q60 Serie Guide D'installation page 14

AXIS Q60 Series
NO TICE TICE
NO NO TICE
Due to local regulations or the environmental and electrical conditions in which the product
is to be used, a shielded network cable (STP) may be appropriate or required. All cables
connecting the product to the network and that are routed outdoors or in demanding
electrical environments shall be intended for their specific use. Make sure that the network
devices are installed in accordance with the manufacturer's instructions. For information
about regulatory requirements, see Electromagnetic Compatibility (EMC) on page 2.
I/O and Audio Connector
Terminal connector for connecting external equipment:
• Audio equipment
• Input/Output (I/O) devices
When connecting external equipment, a multi-connector cable (available from Axis) is required
in order to maintain the product's IP rating. For more information, see Multi-Connector Cable
(sold separately) on page 15.
SD Card Slot
An SD card (not included) can be used for local recording with removable storage. For more
information, see Specifications on page 17.
NO TICE TICE
NO NO TICE
To prevent corruption of recordings, the SD card should be unmounted before removal. To
unmount, go to Setup > System Options > Storage > SD Card and click Unmount.
Note
For SD card recommendations see www.axis.com
Control Button
The control button is used for:
• Resetting the product to factory default settings. See page 26.
• Connecting to an AXIS Video Hosting System service or AXIS Internet Dynamic DNS
Service. For more information about these services, see the User Manual.
Power Button
Press and hold the power button to temporarily power the product when the dome cover is
removed. The power button is also used with the control button to reset the camera to factory
default settings. See page 26.
14