General Safety Notes - Jet JDP-15B Mode D'emploi

The machine must only be used in a technically perfect
condition.
When working on the machine, all safety mechanisms and
covers must be mounted.
In addition to the safety requirements contained in these
operating instructions and your country's applicable
regulations, you should observe the generally recognized
technical rules concerning the operation of wood- and metal-
working machines.
Any other use exceeds authorization.
In the event of unauthorized use of the machine, the
manufacturer renounces all liability and the responsibility is
transferred exclusively to the operator.

3.2 General safety notes

Wood and metalworking machines can be dangerous if not
used properly. Therefore the appropriate general technical
rules as well as the following notes must be observed.
Read and understand the entire instruction manual before
attempting assembly or operation.
Keep this operating instruction close by the machine,
protected from dirt and humidity, and pass it over to the new
owner if you part with the tool.
No changes to the machine may be made.
Daily inspect the function and existence of the safety
appliances before you start the machine.
Do not attempt operation in this case, protect the machine by
unplugging the power cord.
Do not wear gloves while operating this machine.
Remove all loose clothing and confine long hair.
Before operating the machine, remove tie, rings, watches,
other jewelry, and roll up sleeves above the elbows.
Wear safety shoes; never wear leisure shoes or sandals.
Always wear the approved working outfit:
- safety goggles
- ear protection
- dust protection
Install the machine so that there is sufficient space for safe
operation and workpiece handling.
Keep work area well lighted.
The machine is designed to operate in closed rooms and
must be placed stable on a firm and levelled surface.
The machine must be bolted down to avoid tipping!
Make sure that the power cord does not impede work and
cause people to trip.
Never use the power cord to carry the tool.
Do not expose the power cord to heat, oil or any sharp
corners. Do not pull the cord to unplug.
Keep the floor around the machine clean and free of scrap
material, oil and grease.
Make sure the motor fan and fan cover are kept clear of
sawdust.
Stay alert!
Give your work undivided attention. Use common sense.
Keep an ergonomic body position.
Maintain a balanced stance at all times.
Do not operate the machine when you are tired.
Do not operate the machine under the influence of drugs,
alcohol or any medication. Be aware that medication can
change your behaviour.
Keep children and visitors a safe distance from the work area.
Never reach into the machine while it is operating or running
down.
Never leave a running machine unattended.
Before you leave the workplace switch off the machine.
Pull the mains plug if the tool is not in use.
Make all machine adjustments, cleaning or maintenance with
the machine unplugged from the power source.
Before starting the machine, clear all items, such as tools and
rags, away from machine.
Do not operate the electric tool near inflammable liquids or
gases.
Observe the firefighting and fire alert options, for example the
fire extinguisher operation and place.
Do not use the machine in a dump environment and do not
expose it to rain.
Wood dust is explosive and can also represent a risk to
health.
Dust form some tropical woods in particular, and from
hardwoods like beach and oak, is classified as a
carcinogenic substance.
Always use a suitable dust extraction device
Before machining, remove any nails and other foreign bodies
from the workpiece.
Never operate without the chuck guard in place.
Remove the chuck key and wrenches before machine
operation.