OGK Urban Iki Rear seat Mode D'emploi page 5

ENG
Demounting the bicycle seat
The bike seat can also be detached easily when you
are not using the seat.
Step 1: Open the lock
3
2 2
9 O I
1. Enter code
9 O
I
2. Press the two sides
9 O I
3. Uncouple cable
1
Step 2: Remove the cable
Step 3: Remove bike seat from carrier
1. Press button
2. Pull out
8
Scan for
instruction video
1
2
How to Use Your Urban Iki Rear seat
When using the Urban Iki Rear seat bike seat, check to see if the seat is attached
correctly and do a short trial run without your child. If everything functions pro-
perly and you are not hindered when cycling, then you are ready to go cycling
together with your child. Place your child in the seat and attach the safety har-
ness tightly without squeezing. Set the foot rests to the correct height and make
sure that the feet are locked into place by using the foot straps. Always make
sure that no sharp bike parts are within reach of your child and make sure that
your child does not wear clothes that can come into contact with any moving or
turning parts of your bike.
Opening and closing the seatbelt
Buckle belt Unbuckle belt
3
2
CLICK! CLICK!
1
Adjusting seatbelt strap
Tighten belt
Adjust foot supports
Step 1: Unlock Step 2: Slide
Adjusting foot straps
Step 1: Insert foot strap Step 2: Adjust
ENG
3
Scan for
instruction video
2
1. Press
2. Press
1
3. Up
Tip upwards
Pull belt tight
CLICK!
OK
Step 3: Lock
Step 3: Loosen
9