Permobil ROHO HEAL PAD Mode D'emploi page 11

THE ADAPTOR PAD and ROHO DRY FLOATATION Special Application Cushioning Devices Operation Manual
Care Symbols
Hand wash cold, maximum
temperature shown.
30C
Machine wash hot, normal, maximum
60C
temperature shown.
Hand wash.
Troubleshooting
For additional assistance, contact your equipment provider, distributor, or Customer Support.
Not Holding Air:
Uncomfortable or
Unstable:
Cushioning
Device Slides:
Storage, Disposal and Recycling
Storage: Clean and disinfect the product before storing. Open the inflation valve(s). Deflate
the product (detach any product sections). Store the product in a container that protects the
product from moisture, contaminants and damage.
Disposal: The components of the products in this manual are associated with no known
environmental hazards when properly used and when disposed of in accordance with all
local/regional regulations. Incineration must be performed by a qualified, licensed waste
management facility.
Recycling: Contact a local recycling agency to determine recycling options for the product. For
more recycling information, contact Customer Support.
Limited Warranty
Limited Warranty Term: 24 months from the date the product was originally purchased.
The warranty does not apply to punctures, tears, burns, or misuse, nor does it apply to the
removable cover. See also the Limited Warranty supplement provided with your product, or
contact Customer Support.
Line dry in the shade.
Inflate the cushion. Confirm that the inflation valve is completely closed.
Look for holes in the cushion. If very small holes or no holes are visible,
follow the instructions in the Repair Kit provided with your product. For
inflation valve or hose damage, or for large holes or leaks in the cushion,
see the Limited Warranty supplement, or contact Customer Support.
Check the inflation level (see the product instructions). Confirm that the air
cells and the top of the cover face the individual. Confirm that the cushioning
device is not too big or too small for the surface. Allow the individual at least
one hour to adjust to the cushioning device.
Make sure the non-skid bottom of the cover is facing away from the
individual. Confirm that the hook and loop fasteners, straps, or snaps are
securely fastened. When possible, use hook and loop fasteners to further
secure the cushion to the seating surface. Hook fasteners are available
upon request.
Bleach (1 part bleach: 9 parts water)
1: 9
Machine wash gentle, cold, maximum
30C
temperature shown.
9
Tumble dry low.