Setting Up The Remote Control; Using The Remote Control - Canton Digital Movie Notice D'utilisation

Setting up the remote control

Insert the batteries supplied into the remote control. Be careful to insert them the correct way up according to the polarity markings (+/-).

Using the remote control

When all devices are connected to each other and the power has been switched on the
Canton DM goes into Standby mode. Press any key to activate the remote control. If
the remote control is not used for longer than 30 seconds it goes into idle mode. Press
any key to reactivate it.
Note: When the device is turned on for the first time it starts the initial installation
process automatically (see page 36).
If the display shows "keine Verbindung" then there is no radio connection between
the remote control and the DM System. Check that the DM System is switched on
and connected to the mains power supply or reduce the distance between the remote
control and the DM System.
Operating the DM System
Press to start the DM System.
If you want to turn the DM System off again press
again. The DM System will go back into Standby
mode.
Note: If the DM System is disconnected from the mains power supply when it is still switched on it will automatically go back into an active state
when it is reconnected to the mains power supply (e.g. via a master or slave multiple socket lead).
34