Preparation - Wolf CW24/B Guide D'installation

INSTALLATION

Preparation

Remove and recycle packing materials. Do not discard the
package containing two screws provided for installation.
If the cup warming drawer is installed independently, install
an anti-tip block against the rear cabinet wall. Verify screws
are adequately secured and do not penetrate electrical
wiring or plumbing.
Installation
Turn power off to the electrical outlet.
1
Slide the left corner of the cup warming drawer into the
2
opening. If the electrical supply is located in the opening,
plug the power cord into the receptacle. If it is located in
an adjacent cabinet, guide the power cord through the
hole in the cabinet wall. Coil excess power cord behind
or beside the unit.
Slide the unit back into the opening until the trim
3
meets the cabinet front. Avoid pinching the power cord
between the unit and cabinet wall.
Open the cup warming drawer to full extension. Drill a
4
pilot hole in each mounting hole, located at the front, on
each side of the unit. Refer to the illustration below.
Mount the unit using two screws provided.
5
Turn power back on to the electrical outlet.
6
MOUNTING
HOLE
Mounting hole.
Wolf, Wolf & Design, Wolf Gourmet, W & Design and the color red as applied to knobs are registered trademarks and service marks of Wolf Appliance, Inc. Sub-Zero,
Sub-Zero & Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, and Ingredients are registered trademarks and service marks
of Sub-Zero, Inc. All other trademarks or registered trademarks are property of their respective owners in the United States and other countries.
Troubleshooting
IMPORTANT NOTE: If the cup warming drawer does not
operate properly, follow these troubleshooting steps:
• Verify electrical power is supplied to the cup warming
drawer.
• Verify proper electrical connections.
• If the warming drawer does not operate properly, contact
Wolf factory certified service. Do not attempt to repair
the cup warming drawer. Wolf is not responsible for
service required to correct a faulty installation.
|
wolfappliance.com 7