System Enabling; Enabling By The Front Panel Key; Enabling By Other Command System - Hiltron security PROTEC3 Manuel De L'utilisateur

security
4.2

System enabling

4.2.1 Enabling by the front panel key switch
Verify that the zone status LEDs
!
If they're switched on it's necessary to close the doors and windows relative to the zone
signalled opened. It's also possible that the zone signalled opened could be the one
relative to the volumetric detectors; in this case the exiting time will allow to exit the
protected area without activating the alarm.
Turn the key switch
!
The green LED "EXIT"
!
protected areas.
When the exiting time is finished, the green LED "EXIT"
!
system is enabled.
4.2.2

Enabling by other command system

If an electronic key system, a proximity key system, or an electronic keypad system is
installed outside of the protected areas, it's necessary to leave the key switch
"ON" position.
All the SKI connector for the electronic
key, the PXR reader for the proximity key
and the KBC, KBM and KBT keypads have
two LEDs, one green and one red,
indicating the central unit status (see table
beside).
To enable the system:
Verify that the red LED is turned off.
!
If it's turned on, it's necessary to close
the opened doors or windows relative
to the zone that is signalled opened in
the central unit.
Insert the electronic key, or approach
!
the proximity key to the reader, or digit
the code on the keypad.
The green LED turns off indicating that
!
the system is enabled.
and
3
in the "ON" position.
1
starts blinking indicating the exiting time, in which to leave the
8
are turned off.
4
GREEN
LED
GREEN
LED
RED
LED
BOTH
turns off indicating that the
8
ALWAYS in the
1
ON FLASH
System System
disabled disabled
Opened
Alarm
zone/s
memory
Exiting
time
Operating
RED
LED
OFF
System
enabled
Closed
zones
29