Enabling / Desabling System; Enabling System; Desabling System; Optional Command Systems - Hiltron security XR500 Manuel De L'usager

XR500 - User's Manual
4.2

Enabling / Desabling System

4.2.1

Enabling System

Insert the mechanic key in the inserter and turn up to the
!
position "INSERITO" (enabling).
Or:
Put the mechanic key in the position "INSERITO" (enabling).
!
Press the RED button of the remote-control XR20 to enable
!
the system.
When the system is enabled, the green LED blinks to show the exiting time presetted in the
programming mode (par. 3.1.2.2); if the setting is "enabled" (par. 3.1.3.1) the Central Unit utters
several beeps during the exiting time. After this time,
Sirens blink for 3 times and the green LED flashes with few seconds intervals.
4.2.2

Desabling System

Insert the mechanic key in the inserter and turn up to the
!
position "ST/BY" (stand-by).
Or:
Put the mechanic key in the position "INSERITO" (enabling).
!
Press the GREEN button of the remote-control XR20 to
!
desable the system.
The desabing system will be shown by green LED lighting and by a "BEEP" uttered from
the Central Unit.
If an alarm occurs, the impulse of desabling sent by the XR20 will be received both from
the XR500 Central Unit and from the XR300 Siren. This allows a very fast desabling of all
sounding alarms.
4.2.3

Optional Command Systems

You can also connect a kit for electronic key SK103, or key of proximity, or electronic
kehyboard with MONOSTABLE programming to close the contacts in the terminal board
"ON/OFF" for few seconds.
Leaving in "INSERITO" (enabled) position the mechanic key in the inserter, every impulse
sent by the connected command system caused the enabilng/desabling of the system in
sequentially way..
44
all alarm memories set to zero, XR300
security