Lesson 3: Create Messages With Different File Names - Lightcraft 10028035 Mode D'emploi

Here are some important things that you learned from thisfirst example:
• An audible beep is heard when the unit accepts programming input from the remote. This can
assure you that the signal from remote has been received and understood.
• You have the option to save your message at the end of your programming.
• The display always begins with the default method of display as [CYCLIC], which stands for cycle
through all color and method possibilities at random.
• In order to use international charactersin your messages, you should first key in the correspon-
ding equivalent English character and then use the NEXT and PREV to scroll through the inter-
national characters, i. e. (Key in "$" and press NEXT you will see "¢" appears). For any inter-
national characters that do not have a corresponding English character, please key in a SPACE
and then use NEXT and PREV to scroll through the list of available characters.See Appendix D for
Lesson 3: Create messages with different file names
b) Remote Control
To create and edit message used by remote control, you should follow the below steps. If there is a
previously stored message under that file number, the display will show [OLDFIL][CYCLIC], or may
not be [CYCLIC]depending on actual content.
Step# Buttons
1 PROG
2 01 ENT
RUN
6
7 Y
In some cases, you might like to erase some of the messages; the device has an easy option for this
scenario. After entering the edit mode, press CLR and scroll through the difference functions with
PREV/NEXT.
DEL ALL (delete ALL messages) - DEL FILE ?? (delete file XX) - DEL MSG (delete current message) -
DEL ON/OFF (delete auto timer setting) - DEL ALARM (delete alarm setting).
Explanation
Enter the programming mode
This is the number of the previously saved file
You can now edit or create a new message
Exit the programming mode.
Y (Yes): Re-Save
a) Software
Press CTRL + ENTER, to crea-
te a new file Slots 01 - 99 are
available in the internal memo-
ry of the display.
Display shows:
OPEN: ??
OLDFIL [CYCLIC]
SAVE? (Y/N)
Message will be
displayed
33