Bort MASTER ECO Mode D'emploi page 11

GB ENGLISH
INSTALLATION INSTRUCTIONS, MAINTENANCE
AND USING THE DISPOSER
Before installing the product, read everything
carefully . Installation, maintenance and use man-
ual . Before starting work determine which tools,
materials, and equipment you need .
Before installing the disposer, make sure that you
have all the necessary parts of the product .
REQUIRED TOOLS AND MATERIALS:
- Screwdriver;
- Hinged pliers;
- Insulation tape;
- Protective glasses .
REQUIRED INSTRUMENTS, MATERIALS AND
OPTIONAL EQUIPMENT:
- A phillips screwdrive;
- A drainage drill;
- Electrical terminal 9 .5 mm;
- Threaded nuts (2);
- Siphon 38 mm;
- Drill 25 mm;
- Hammer;
- Hacksaw;
- Water hose clamp;
- Pipe pliers;
- Copper grounding wire;
- Dishwasher drainage pipe kit;
TECHNICAL SPECIFICATIONS (fig . 1)
Watt consumption
Rate of rotation
Output
Chamber volume
Start button
Protective system
Noise level
Designed for
Weight
Voltage / Current frequency
390 W
2600 rpm
3,2 kg/min
1000 ml
Pneumatic
Overloading and
seizure protection
58 db
3 persons
4 kg
220 V / 50 Hz
11
- Electric switch;
- Extension pipe .
1. DESCRIPTION OF THE PRODUCT (Fig.2)
1 . Stopper;
2 . Removable mudguard;
3 . Drain flange;
4 . Rubber shim (or sealant material);
5 . Fiberboard gasket;
6 . Base ring (arrows up);
7 . Retention ring;
8 . Lugs for torquing;
9 . Sealing;
10 . Gorge;
11 . Reducing pipe to dishwasher;
12 . Grinding chamber;
13 . Pipe elbow's fitting;
14 . Reset button (in front);
15 . Screws;
16 . Elbow's flange;
17 . Outlet elbow .
2. DISCONNECTION OF THE DROP HORN
ATTENTION!
At the time of installation of the device is recommended
Wear safety glasses .
- Loosen the nut (1) on the top of the water trap (4) with a
pipe wrench (Fig . 3) . Loosen the nut (2) on the top of the
extension pipe . Remove the extension pipe .
- Loosen the nut (3) at the bottom of the washing flange .
- Push the washing flange upwards through drain hole of
the sink and remove it (Fig . 4) .
- Clean the wash fan wrapping place from the sealant or
the garbage .
NOTE: It may be necessary to expand the drain hole for
installation flange fastening disposer . Equipment for
extending the drainage hole is purchased separately .
3. INSTALATION OF MOUNTAING MASTER
ECO
ATTENTION!: To install the disposer, the thickness
of the sink in the area of the drain hole should be
no more than 18 mm.
1.
Remove disposer mounting assembly by turning
the mounting ring to the left (clockwise) .
2.
Raise the fixing ring to the drain flange . Remove
seal . Remove retaining ring . It is advisable to pre-
practice installing the seal in the desired position . See
section «Seal Features» .
3.
Unscrew the support ring from the drain flange and
remove the cardboard pad . Now you can remove the