Using The Keypad - eufy Security T8960 Mode D'emploi

2. Place the mounting plate against the wall, matching UP and Down as indicated
on the back of the mounting bracket. Push a pencil tip through the holes on the
mounting bracket to mark the location for mounting the keypad.
3. Drill holes with a drill bit (15/64" / 6 mm) at each marking.
4. Insert anchors into the holes, and fix the mounting bracket onto the wall with the
provided screws. No anchors are needed on wooden walls.
06 English
5. Slide the keypad down until it snaps perfectly onto the mounting bracket.

USING THE KEYPAD

Keypad Mode Introduction
The Keypad features four modes: Away, Home, Customized and OFF, which are
associated with four Keypad buttons respectively.
Away mode: All sensors will be activated and your house will be
monitored. The system is armed. Any movement will be detected and
an alarm will be triggered. Recommended using when you are away
from home.
Home mode: Interior sensors are disabled, while the exterior sensors
are activated. Recommended using when you are at home and want to
be alerted about any break-ins outside the house.
Customized mode: Recommended if you feel a customized security
mode is needed to match your specific life requirements.
OFF mode: No sensors are activated, while the camera is set to ON by
default.
English 07