Assembling The Grass Catcher - Ryobi RY40108 Manuel D'utilisation

ASSEMBLING THE GRASS CATCHER

See Figures 5 - 6.
 Place the grass catcher frame on a flat surface with the
handle facing down.
 Orient the grass catcher bag so the vinyl floor is facing up,
then slide the frame into the bag. When installing, allow
the frame handle to remain outside the bag and make
sure the bag seams are located at the frame edges.
 Pull the clip over the frame rail to secure in place.
 Lift the bag's vinyl floor to the top of the frame rail and
secure in place.
 Using the same method, attach the remaining clips on
each side of the bag to the frame rail to secure.
INSTALLING THE GRASS CATCHER (FOR REAR
BAGGING OPERATION)
See Figures 7 - 8.
NOTE: When using the grass catcher, do not install the
mulching plug.
 Remove start key and battery pack.
 Lift the rear discharge door.
 Lift the grass catcher by its handle and place under the
rear discharge door so that the hooks on the grass catcher
are seated onto the slots on the mower housing.
 Release the rear discharge door.
 Reinstall start key and battery pack when you are ready
to mow.
ASSEMBLY
SETTING BLADE HEIGHT
See Figure 9.
When shipped, the wheels on the mower are set to a low-
cutting position. Before using the mower for the first time,
raise the cutting position to the height best suited for your
lawn. The average lawn should be between 1-1/2 in. to 2 in.
during cool months and between 2 in. and 3-1/4 in. during
hot months.
To adjust the blade height:
 Remove start key and battery pack.
 To raise the blade height, grasp the height adjustment
lever and move it toward the back of the mower.
 To lower the blade height, grasp the height adjustment
lever and move it toward the front of the mower.
 Reinstall start key and battery pack when you are ready
to mow.
8 — English