Presets; Tours - FLIR Lorex LNZ32P12 Manuel D'utilisation

5 Controlling the PTZ Camera with an NVR
5. Autopan: Click to start autopan. During autopan, the camera will continuously pan
360°.
6. Tour: Click to run the selected tour.
7. Not supported.
8. Pattern: Click to run the selected pattern.
9. Not supported
10. Auto scan: Click to run the selected autoscan.
11. : Click to open the PAN/TILT/ZOOM menu, where you can set up Presets, Tours,
Patterns, and Auto Scans.

5.2.1 Presets

Presets will save a camera position for quick retrieval.
To add presets:
1. Click to open the PAN/TILT/ZOOM menu.
2. Click the Preset tab.
3. Enter the number of the preset you want to create under Preset.
4. Move the camera to the desired position and click Set.
To go to a preset:
• Under No., select the number of the preset you would like to go to and click

5.2.2 Tours

Tours will cycle through a set of presets.
To create a tour:
1. Click to open the PAN/TILT/ZOOM menu.
2. Click the Tour tab.
3. Under Patrol No., select the tour you would like to configure.
#LX400020; r.35429/35429; en-US
.
15