Bradley S19-869 Mode D'emploi page 4

S19-869, S19-869EXP
Instructions
Step 1: Mount indicator light to unit
1. Choose a location for mounting the indicator light.
• The indicator light may be mounted directly to the unit junction box at one of the locations
shown in Figure 1 below.
Step 2: Make electrical connections
1. Connect the indicator light to the junction box following the wiring diagram (Figure 2).
Figure 1
UNIT
JUNCTION
BOX
MOUNTING
LOCATION FOR
INDICATOR LIGHT
(NOTE: A TEE FITTING WILL BE REQUIRED
AS THIS PORT IS ALSO USED FOR
INCOMING POWER SUPPLY FOR UNIT)
Figure 2
4
INDICATOR LIGHT WIRING DIAGRAM
GREEN
WHITE
BLACK
POWER
11/12/07
INDICATOR
LIGHT
HEAT TRACE
CABLE
THERMOSTAT
Bradley Corporation • 215-1365 Rev. A; EN 07-530
HEAT TRACE
DRENCH
SHOWER
GROUND
SCREW-IN
JUNCTION
BOX
Installation