Bradley S19-869 Mode D'emploi page 2

S19-869, S19-869EXP
Read this installation manual completely to ensure proper installation, then file
it with the owner or maintenance department. Compliance and conformity to
Installation
drain requirements and other local codes and ordinances is the responsibility
of the installer.
Separate parts from packaging and make sure all parts are accounted for
Packing List
•
before discarding any packaging material. If any parts are missing, do not
•
•
IS
T H
E
•
S ID
U P
begin installation until you obtain the missing parts.
Flush the water supply lines before beginning installation and after installation
is complete. Test the unit for leaks and adequate water flow. Main water supply
to the eyewash should be "ON" at all times. Provisions shall be made to
prevent unauthorized shutoff. Flushing fluid should be tepid per ANSI Z358.1.
The inspection and testing results of this equipment should be recorded
weekly to verify proper operation. This equipment should be inspected
annually to ensure compliance with ANSI Z358.1.
Workers who may come in contact with potentially hazardous materials
should be trained regarding the placement and proper operation of emergency
equipment per ANSI Z358.1.
P.O. BOX 309, MENOMONEE FALLS, WI 53052-0309 USA
TEL: 1-800-BRADLEY FAX: (262-251-5817)
http://www.bradleycorp.com
114-051
For questions regarding the operation or installation of this product, visit www.
bradleycorp.com or call 1-800-BRADLEY.
Product warranties may also be found under "Product Information" on our web
site at www.bradleycorp.com.
2
WARNING
11/12/07 Bradley Corporation • 215-1365 Rev. A; EN 07-530
Installation