Sport-Tec PULL-UP 10.0 Mode D'emploi page 10

ASSEMBLY
Please note:
Before assembling the pull-up bar, first read through all the instructions carefully.
Before installation, please ensure that the door frame is not damaged, that it is suitable for mounting the door
bar (real wood doors, security doors) and that it has sufficient load-bearing capacity. Do not mount between glass
surfaces and other unstable surfaces.
Please note that the maximum load-bearing capacity may not be identical for all door frames. The load-bearing
capacity always depends on what the door frame is made of.
Place the pull-up bar at the base of the desired door frame.
Now push the pull-up bar up to the desired position of the door
frame. Make sure that the bar is placed horizontally in the door
frame. The built-in water level makes it easier for you to align.
10
Sport-Tec GmbH ∙ Physio & Fitness ∙ www.sport-tec.de
Adjust the length of the pull-up bar to the width of the door
frame by turning the adjustable screw ❶. Use an Allen wrench
for this. The adjustable screw is located on the underside of the
centre section ❷. Turn it until the bar makes contact with the
door frame.
Now turn the adjustable screw until the bar is firmly seated in
the door frame.
❷
❶