RAB Design WL1S-LED Instructions D'installation

WL1S-LED
INSTALLATION INSTRUCTIONS
ELECTRICAL SHOCK HAZARD
WARNING
Disconnect the Electrical supply power at the service panel (fuse or circuit breaker box). Failure to do so could result in serious
injury or death. Only qualified electricians should install this fixture and the installation MUST conform to the Canadian
Electrical Code Part I and all local codes and ordinances. Ensure that only proper tools, materials, and equipment are used to
complete the installation.
SAFETY
•
Proper grounding is required to ensure personal safety.
•
Fixture should be mounted in locations where unauthorized personnel will not readily subject it to tampering.
•
Do not use this equipment for anything other than its intended purpose.
•
Servicing this equipment should be performed by qualified service personnel.
•
Save these instructions.
•
MIN 90 °C SUPPLY CONDUCTOR
INSTALLATION
Tools Required:
- Screwdriver and Drilling tools.
Wall Mount
- Open the fixture by loosening the screw at the bottom of the fixture. [1]
- Attach the gasket to the back of the rear housing. [2]
- Prepare the rear housing for installation by drilling the appropriate holes.
[3]
- Mount the rear housing at desired location using the appropriate screws.
Ensure that the top, both sides and the mounting holes that are touching
the wall are sealed with silicone.
- Hang the front housing on to the anti-drop screw attached on the rear
housing and make appropriate wiring connections as per wiring diagram.
[4]
- Hook the front housing back to the rear housing. [5]
- Close the front housing and tighten the bottom screw.
RAB Design Lighting inc.
READ, UNDERSTAND
before installing the equipment.
May – 2022
FOLLOW
, and these instructions
4
Page 1 of 2
1
2
3
5