RAB Design WRDS-LED Instructions D'installation

INSTALLATION INSTRUCTIONS
IMPORTANT: READ CAREFULLY BEFORE INSTALLING FIXTURE. SAVE THESE INSTRUCTIONS.
WARNING: Before installation disconnect power by turning off the circuit breaker.
Turning the power off by using the light switch is not sufficient to prevent electrical shock.
SAFETY: This fixture must be wired in accordance with the Canadian Electrical Code, and
applicable local codes and ordinances.
A qualified electrician should perform all wiring.
Proper grounding is required to ensure personal safety.
Fixture is for outdoor use and should not be used in areas of limited ventilation or high
ambient temperature.
Fixture should be wall mounted, at least 12" away from any combustible materials
Fixture should not be recessed
INSTALLATION & WIRING:
POWER SUPPLY WIRES:
 min. 90
0
C rated wires when connecting wire leads in junction
box.
 min. 105
0
C rated wires when connecting wires leads inside the
fixture.
WALL MOUNTING - Fig. 1
1. Install mounting plate (1) on junction box with screws
2. Use approved connectors to connect fixture leads (2) to power
supply leads and push connectors inside the junction box
3. Attach fixture to mounting plate using retaining screws (3)
4. Use silicone sealant around housing except bottom of fixture
WARNING:
 Fixtures are available in 120 to 277 volt input (not for connection to a voltage above 240Vac in
Canada). Please verify voltage before wiring fixture.
IMPORTANT:
 To weather-proof your outdoor installation, be sure to seal all housing (mounting, conduit, plugs, etc.)
with silicone sealant.
WRDS-LED
Fig. 1
WRDS-LED