Emptying The Dust Cup; Detaching The Dust Cup And Filters - VALBERG CYCLONIC-S3 Consignes D'utilisation

C
Cleaning and maintenance

Emptying the dust cup

• To empty the dust cup, turn off the vacuum cleaner.
• Detach the extension hose and/or vacuum tool from the main unit's air inlet.
Hold the main unit vertically over a bin. Press the lid lever down. The lid on the bottom
of the dust cup will flip open. Close the lid after emptying the contents.

Detaching the dust cup and filters

Pull the dust cup at an angle to detach it from the main unit.
Remove the foam filter from the top of the dust cup.
Lift the filter basket to remove it from the dust cup and then twist the bottom part
towards the
a bin to dislodge the dust.
Rinse the dust cup, filter basket and both filters under a tap.
Shake off any excess water and let the different parts dry completely.
• To re-assemble the filters and dust cup, carry out the steps in reverse order. Align the top
with the bottom of the filter basket and twist the bottom towards the
• Next, insert the filter basket assembly into the dust cup, aligning the raised notch on the
basket with the groove on the cup. Place the foam filter on top, white side up.
• Insert the assembled dust cup onto the main unit at an angle, aligning the small groove
on the neck of the dust cup with the raised notch on the main unit. Push the dust cup
until it clicks into place.
icon. Hold the permanent dust filter assembly and gently tap it over
22 EN
icon.