Installing The Wall Mount - VALBERG CYCLONIC-S3 Consignes D'utilisation

B
Product usage
Detaching the tools
• Make sure the unit is switched off.
• Pull off the crevice tool/2-in-1 brush tool or press the release button on the extension
hose/motorised turbo brush to detach the tools from the main unit.
Operation
• To turn on the vacuum cleaner, slide the Power switch forward to the LOW or HIGH speed.
The LED indicator(s) will turn on and indicate the current battery level (1 – 5).
• To turn off the vacuum cleaner, slide the Power switch all the way back to the Off position.
The LED indicator(s) will turn off.
• Empty the dust cup before its contents exceed the "MAX" level mark (see "Emptying the
dust cup" in the Cleaning and Maintenance section).
• Once you have finished using the unit, always turn it off. To clean the unit, follow the
instructions in the Cleaning and Maintenance section.
• Charge the vacuum cleaner after each use to ensure the unit is fully charged and ready
for the next use.
NOTE: When vacuuming heavily soiled surfaces, regularly turn the unit off and
check the mouth of the tool to ensure that it is clean and to avoid scratching
delicate surfaces.

Installing the wall mount

WARNING!
• Securely install the wall mount on a wall that is strong enough to support
the weight of the unit.
• Install the wall mount in a dry area, away from extreme heat or cold, and
ideally close to a mains socket.
The wall mount (with the supplied wall plugs and screw) can be installed to easily store the
vacuum cleaner.
Place the wall mount on the wall, leaving a space of at least 110 cm between the floor
and the bottom of the wall mount. Mark the drill holes for the screws with a pencil. Then,
drill the holes and insert the wall plugs. Place the wall mount over the wall plugs and
tighten the screws using a screwdriver.
DANGER! RISK OF ELECTRIC SHOCK!
• Do not pierce the electric cables (or water pipes) located in the wall.
• Do not install the wall mount on a metal wall.
20 EN