Polaris GLACIER II Mode D'emploi page 9

MOUNT PLATE FOR "GLACIER II" PLOW FRAME
KIT PN 2879116
2. Bore the lower rubber cover of the limit switch d.
Insert the connector (short) f as illustrated.
6
3. Fasten the connector (short) f onto the limit switch
d as illustrated.
4
4. Fasten the limit switch d to the limit switch bracket
e using the
(2) M4-0.7 X 35 mm
flat washers n, and the
Make sure to use the correct mounting holes.
7515260
A-7515260
4
WHITE
6
BLACK
hex bolts l, the
(4) M4
nylock nuts p.
(2) M4-0.7
Use the No.2
Mounting Holes
- 3-
5. Position and fasten the limit switch bracket e to
pushframe using the
(2) M4-0.7 X 16 mm
the flat washers n, and the
(4) M4
nuts p.
IMPORTANT: The limit switch bracket e is
designed to ensure accurate positioning of the limit
switch. For optimum performance, make sure to
position the right side of the bracket at the top of the
mounting opening.
UPPER VIEW
NOTE: If the limit switch bracket has been
properly installed, the limit switch will be
positioned at an angle of 5° as shown.
hex bolts k,
nylock
(2) M4-0.7
Printed in China