Replacing The Monitor - NAMCO POINT BLANK 2 Manuel De L'opérateur

5-8

Replacing the Monitor

NOTE:- THE MONITOR IS HEAVY. AT LEAST 2 PEOPLE ARE REQUIRED TO
REMOVE THE MONITOR
1. Remove the Play Panel.
2. Remove the front glass by lifting it out of the grooves at the bottom and drawing it
forward.
Store the glass in a safe place where it will not get broken or cause a danger.
3. Remove the rear door from the cabinet.
4. Disconnect the monitor connectors.
5. Remove 4off pozi head screws (M5x16), with flat and spring washers, and
remove the mirror holders. Remove the mirror.
Store the mirror in a safe place where it will not get broken or cause a danger.
6. Remove the Monitor Mask.
7. Remove 4off pozi head screws (M6x16), with flat and spring washers, retaining
the monitor to cabinet.
(see section 5-1 page 51)
Page 58