Replacing The Gun Cable - NAMCO POINT BLANK 2 Manuel De L'opérateur

5-7

Replacing the Gun Cable

1. Remove the Gun Assembly.
2. Remove the Gun Slides.
3. Remove the gun sides.
4. Detach the solenoid bracket, connector and ground wire.
(see section 5-6 page 56)
5. Disconnect the sensor and detach the fast-on connectors from the micro switch.
6. Remove the button bolt (M4x10) fixing the conduit to the gun cover (L).
7. Remove 2off button bolt (M4x10) and remove the connector cover.
8. Reassemble in reverse order ensuring that the earth wire is secure.
(see section 5-3 page 53)
(see section 5-4 page 54)
(see section 5-5 page 55)
Page 57