Replacing the lamp unit
If the projector is operating, turn off the power by the following procedure and wait for the lamp
unit to cool down before carrying out replacement.
(1) Press the Power button twice to turn the projector off.
(The power indicator lamp will illuminate orange.)
(2) Wait until the power monitor on the projector turns red or starts fl ashing.
(3) Turn off the MAIN POWER switch and disconnect the power cord plug from the wall outlet.
■
Replacement procedure
1)
Make sure that components in the vicinity of the lamp unit are cool.
2)
Use a Phillips screwdriver to turn the lamp
cover fi xing screws (lamp unit compartment
fi xing screw) (x2) on the projector rear panel
until the screws turn freely and remove the
lamp cover (lamp unit compartment).
Remove the lamp cover by gently pulling it in the
direction of the arrow in the fi gure.
The location of the screws may differ with projector
model. Check the operating instructions supplied
with the projector for information on screw location.
3)
Use a Phillips screwdriver to loosen the two
lamp unit fi xing screws until the screws turn
freely, and then hold the handles of the lamp
unit and gently remove the lamp unit from
the projector.
4)
Insert the new lamp unit while making sure
that the direction is correct, and then use a
Phillips screwdriver to securely tighten the
two lamp unit fi xing screws.
When inserting the new lamp unit, be particularly
sure to push it in at point
5)
Insert the lamp cover (lamp unit compart-
ment) and then use a Phillips screwdriver
to securely tighten the two lamp unit fi x-
ing screws (lamp unit compartment fi xing
screws).
Install the lamp cover by gently pushing it in the di-
rection of the arrow in the fi gure.
A
.
Lamp cover
lamp unit
fixing screws
Lamp unit fixing screw
Lamp cover
fixing screw
handles
E-2