Important Safety Instructions - Outsunny SPA GONFLABLE Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN
WARNING 1:
WARNING 2:
WARNING 3:
WARNING 4:
WARNING 5:
WARNING 6:
WARNING 7:
WARNING 8:
WARNING 9:
WARNING 10:
WARNING 11:
WARNING12:
WARNING13:
WARNING14:
WARNING15:

IMPORTANT SAFETY INSTRUCTIONS

The appliance should be supplied through a residual current device (RCD) with a rated tripping
current not exceeding 30 mA.
Electric installations should fulfill the requirements of local standards. Earthed appliances must be
permanently connected to fixed wiring
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or
a similarly qualified person in order to avoid a hazard. Replace damage cord immediately.
Parts containing live parts, except parts supplied with safety extra-low voltage not exceeding
12 V, must be inaccessible to a person in the bath.
To reduce the risk of electric shock, do not use extension cord to connect unit to electric supply;
provide a properly located receptacle.
Parts incorporating electrical components,
or fixed so that they cannot fall into the bath.
To avoid electric shock, do not use the spa when it is raining.
Never operate the spa if the suction fittings are broken or missing. Never replace a suction fitting with
one rated less than the flow rate marked on the original suction fitting.
To reduce the risk of injury, do not permit children to use this product unless they are closely supervised
at all times.
Water attracts children. Always have the spa locked with its cover after each use.
When the jet function is going to be used, make sure the cover of spa is opened first.
Do not switch on if there is any possibility that the water in the spa is frozen.
Risk of electric shock. Never operate any electrical appliance when in the spa or when your
Body is wet. Never place any electric appliance, such as a light, telephone, radio, or television, within 5
feet (1.5m) of a spa.
Pets should be kept away from spa to avoid damage.
Risk of electric shock. Install at least 5 feet (1.5m) from all metal surfaces. As an alternative, a
Spa may be installed within 5 feet of metal surfaces if each metal surface is permanently
connected by a minimum 1.0 mm
terminal box that is provided for this purpose.
except for remote control devices, must be located
2
solid copper conductor to the wire connector on the

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

848-013v81

Table des Matières