ELBROLIGHT EBM270/W Mode D'emploi page 22

Install the unit away from direct sunlight.
•
If possible, avoid locations near bushes, trees or pets.
•
The sensor has its highest sensitivity to movements tan-
•
gential to (passing straight by) the unit, and the lowest
2
sensitivity to radial movements directly toward or away
from the detector.
Installation:
There are four different ways of mounting the Motion Sensor:
Wall mounting
•
Ceiling mounting
•
Inside corner mounting
•
Outside corner mounting
•
1. Wall mounting
Unscrew and remove the front cover with a screwdriver.
•
3
Install the sensor unit on the wall using two screws.
•
After connecting the wires to the sensor unit, click in the
•
4
front cover and fasten it with the removed screw.
2. Ceiling mounting
Same procedure as wall mounting, but just install the
•
5
sensor on the ceiling.
3. Corner mounting, inside or outside
Mount the Corner Mounting Plate using two screws.
•
6
Install the sensor unit on the Corner Mounting Plate using
•
two screws.
After connecting the wires to the sensor unit, click in the
•
front cover and fasten it with the removed screw.
Wiring instructions:
Breakout one of the two holes of the seal feed-through.
•
Run the power cable through the rubber gasket.
7
•
Strip 6 to 8 mm from the cable.
•
Before connecting it, ensure that the cable is cleanly posi-
•
tioned in the feed-through ring.
22