Cleaning And Maintenance; Regular Inspections - Amica PMG2.0ZpZtR Notice D'utilisation

CLEANING AND MAINTENANCE

Proper routine maintenance and cleaning
of the appliance can significantly extend its
trouble-free operation.
B e f o r e c l e a n i n g o r o t h e r
maintenance work, always unplug
the appliance or use the main
electrical system circuit breaker
to cut off power. Do not begin
cleaning until the hob has cooled.
Do not use abrasive scouring
powders.
Do not use steam cleaning
equipment for cleaning.
Burners,
hob grid
l If the burners and grid become soiled,
remove them from the hob and wash in
warm water with some dishwashing liq-
uid. Wipe dry. Once the grid is removed,
thoroughly clean the area under the
burner and wipe it dry with a soft cloth.
Flame outlets and burner head must be
clean at all times, see figure below. Clean
the gas nozzles using a thin copper wire.
Do not use steel wire or ream the holes.
All burner parts must be always
dry. Water droplets may block the
gas flow and cause the burner to
operate incorrectly.
Make sure that burner is correctly
re-assembled after cleaning.
CORRECT
INCORRECT
l Use mild detergents to wash enamel
surfaces. When cleaning do not use abra-
sive cleaners such as scouring powders,
pastes, abrasive stones, pumice, metal
scrubbers, etc.
l Thoroughly clean the stainless steel
hob before use. Especially make sure to
remove any adhesive residue or self-ad-
hesive tape applied when the appliance
was packaged.
l Clean the hob after each use. Do not
allow the hob to get heavily stained;
particularly from burnt–on spillages from
boiled over liquids.

Regular inspections

In addition to normal cleaning and mainte-
nance:
● carry out periodic checks of touch controls
and other elements. After the warranty
expires, have authorised service inspect
the appliance every two years,
● repair any operational faults,
● carry out periodic maintenance of the hob,
42