Table des Matières
Publicité
Installation du ventilateur arrière (sku # 99000138)
Le ventilateur arrière améliore le transfert de chaleur en poussant l'air chauffé à travers le canal de
convection. Les instructions d'utilisation sont décrites au chapitre "Fonctionnement du ventilateur".
1
Le poêle doit être en place avec les pattes installées avant d'installer le ventilateur arrière.
2
Suivez les instructions ci-dessous pour installer le thermodisque.
These wires pass
through the left side
convection channel.
Thermodisk
Assembly
3
Installez le serre-câble en suivant les instructions ci-dessous..
4
Attach the blower following the directions below.
Attach the quick-connects
a
leading from the snap disk to the
quick-connects from the blower
(orientation does not matter).
© Travis Industries
Optional Equipment
Wire Clip
Snap Disk
Wires
12/1/2017 -1510-FR
Bend metal up or down
here to create a snug fit
Use a screwdriver to
pry out the knock-out.
Slide the wire clip
over the edge of the
strip of metal between
the two knock-outs.
The blower attaches to the stove with the three
b
included screws. Use a 3/8" socket driver or wrench.
Plug the power cord into a 110 V. outlet after installing the
c
blower.
Air
Contro
Rod
Insert the thermodisk
assembly 4" to 5" inside
the convection channel.
Feed the two snap disk wires into
the eye of the wire clip. Remove
all slack from the wire, making
sure not to dislodge the snap disk.
Pinch the eye of the wire clip to
secure the wires.
WARNING:
To prevent electrical shock, the
wires must be secured so they do
not contact the firebox above the
convection channel.
3/8" Nutdriver
NOTE:
Prior to attaching the blower,
tuck all excess wire into the
area inside the blower.
45
Answer
Publicité
Table des Matières
