Cheminée Extérieure Construite En Usine; Foyer Poêle Connexion Positive - Lopi Answer Manuel Du Propriétaire

Cheminée
extérieure
construite en
usine
REMARQUE:
Les cheminées
extérieures sont
soumises à une plus
grande accumulation
d'humidité et de
créosote en raison des
températures plus
basses. Une chasse
isolée réduira ces
accumulations (les
dégagements
nécessaires à la
cheminée doivent être
maintenus).
Foyer poêle
connexion
positive
REMARQUE:
La plupart des
fabricants de cheminées
fabriqués en usine
fabriquent des gaines
de cheminée en acier
inoxydable, flexibles ou
rigides. Ceci fournit une
grande variété d'options
d'installation. Assurez-
vous de suivre les
instructions du fabricant
pour l'installation et
l'assistance.
© Travis Industries
Stove Installation
Chimney Cap
(See the section "Chimney
Termination Requirements"
for more details)
Chimney Sections
Minimum Air Space to
Combustibles (See
Chimney Manufacturer's
Instructions)
Min. 18"
(457mm)
clearance to
ceiling
Chimney Connector
Sections
Floor Protection
(See "Floor
Protection
Requirements"
for details)
NOTE: The entire fireplace and
chimney must be clean, undamaged,
and meet all local building codes
(UBC, etc.). Damage must be
repaired prior to installation. The
chimney must be 15' to 33' tall.
Combustible
Mantle
Floor Protection
(See the section
"Floor Protection
Requirements"
for more details)
(for qualified installers only)
Wall Bands
and
Supports
Min. 36"
12/1/2017 -1510-FR
}
Minimum 15' (4.57M)
Maximum 33' (10.05M)
Insulated Tee
(with cleanout )
Stove Clearances
(See the section "Stove
Placement Requirements"
for more details)
17
Follow the chimney
manufacturer's
instructions and
clearances for roof
penetrations. A storm
collar and flashing are
required (some
require a radiation
shield).
Follow the chimney
manufacturer's
instructions and
clearances for wall
penetrations. A
wall radiation shield
(thimble) is
required.
Optional
insulated
chase
Figure 12
Cap and flashing
prevents water from
entering
The liner must be
stainless steel conne
or flexible vent. Follo
the liner manufacture
instructions for instal
and support.
Airtight Insulated
Clean-Out
Remove damper
or wire it open
See the section
"Stove Placement
Requirements" for
minimum clearances
required.
Figure 13
Answer