Wall Mounting
Before Wall Mounting the monitor,
download the app and complete the
pairing process. This will help ensure
optimal placement. The following
instructions are for securely mounting to
a drywall surface.
1 . Examine the room and determine the optimal placement on the
wall. Mark this location with a pencil. IMPORTANT: Ensure that
the baby monitor is at least 3 ft (0.9 m) away from the crib.
2 . Place the included wall mount onto the wall
at the marked location, ensuring the arrow is
pointing upwards. Using a pencil, make a mark
through the two screw holes. Put the wall mount
to the side for later use.
3 . Using a 3/16" drill bit, drill a hole 1.0" (2.54 cm) deep on the
pencil marks. DO NOT drill through the wall mount holes.
4 . Insert drywall anchor into the hole. If necessary, lightly tap
with a hammer until the drywall anchor is flush with the wall
surface. Note: If mounting to a wall stud, drywall anchors are
not required.
5 . Align the holes of the wall mount with the
drywall anchors and using a screwdriver,
hand tighten a screw into each of the drywall
anchors. DO NOT over tighten.
3'
3'
continued on next page
(0.9 m)
3'
(0.9 m)
(0.9 m)
3'
3'
(0.9 m
8