Demo Software; Protocol; Control Via Foot Switch Or Remote Control; Maintenance - Scott KL 2500 LED Conseils D'utilisation

Table des Matières

Les langues disponibles

KL 2500 LED – Operating instructions

3.2 Demo software

SCHOTT's demo software is designed to show which control functions are possible using the USB

connection. It is not fully developed control software and only serves to demonstrate!

SCHOTT's demo software can be requested at the below mentioned address.

All information such as port settings, formats, control commands, error codes etc. for integrating the

KL 2500 LED into individual control software are described in our separate info sheet.

The "Protocol for Communication with KL 2500 LED" info sheet can be downloaded from our

website at

" http://www.schott.com/lightingimaging/english/lifescience/microscopyproducts/KL/KL2500LED.html".

Illumination using the KL 2500 LED can be switched on and off via a foot switch (accessory) or key

button (shuttering).

Connect at the corresponding connecting socket (14) on the back of the light source.

If the illumination is switched off (brightness 0.0%) this will be shown in the display (12) via the

indicator "SHUTTER".

Further, the brightness setting of the KL 2500 LED can be adjusted via a remote control

(accessory).

For this purpose connect the remote control at the corresponding connecting socket (14) on the

back of the light source.

By pushing the plus- or minus button at the remote control, light source can be switched on or off

(shuttering). To activate the remote control modus at the light source, the light intensity setting knob

(1) of the light source must be pushed and hold for a while. The LCD-display (12) indicates

"REMOTE". By pushing the plus- or minus button at the remote control, the brightness setting of the

light source can be adjusted. Increment steps are the current adjusted (0.1%, 1.0%, 5.0%).

The remote control modus can be switched off by pushing the light intensity setting knob (1). The

indication "REMOTE" disappears at the LCD-display (12).

Your KL 2500 LED is maintenance-free.

The light source should not be disinfected for use in medical applications.

To clean the outside of the instrument please use a soft dry cloth or commercially available plastic

cleaning cloths.

9/12

Table des Matières