Control Via Usb; Installation - Scott KL 2500 LED Conseils D'utilisation

KL 2500 LED – Operating instructions
When operating the light source the filter slide must always be engaged in one of the end positions
or in the rest position. This is the only way to guarantee optimum air cooling of the light source.
Safety information:
WARNING !
Operating the light source with the filter slide in an intermediate position can cause damage to the
slide.
Fitting the filter slide
Please ensure the filter slide (8) has cooled down before fitting the insert filter.
Completely pull out the filter slide (8) from the light source and slot the required filter from the filter
set into the provided holder, ensuring the filter is lying flat in the holder.
Push the filter slide as far as the stop to ensure the filter is positioned in the optical light path.
If you wish to operate the light source for a short time without a filter then only pull the slide out to
the first rest position. In this position the filter is still in the light source, but no longer in the light path.

3. Control via USB

Your KL 2500 LED comes with a USB port making it possible to be controlled by computer using the
USB connecting cable supplied. SCHOTT provides demo software (see Point 3.2) to demonstrate
the control function, installable on request at below mentioned address. It is also possible to
integrate the light source controlling in individual software by linking the corresponding protocol
commands (see Point 3.3.).
3.1 Installation of USB driver
To facilitate communication between the KL 2500 LED and your computer, the corresponding driver
first has to be installed. This can be requested at the below mentioned address.
Connect the light source via the connecting socket (13) to your computer using the USB connecting
cable provided and switch the light source on at the on/off switch (2). When first switching on, your
operating system prompts you to install the new USB appliance. Follow the instructions of your
operating system. Make sure that the driver is saved in a suitable path.
8/12