Paramount LIP 10 A TGG Manuel D'instructions page 8

STEP 4
4-1 Carefully insert gas inlet hose completely through the post
resting heater head unit on the support post.
4-2 Make sure both components are level and aligned with
holes of the support post with the holes at the bottom of the
head unit. Attach using 4-M6 x 10mm bolts. Use a Phillips head
screwdriver to tighten securely
For questions, replacement parts, service help or
other assistance, please call the Customer Service Hotline!
STEP 5
through the pre-drilled holes. Attach using washers and cap
nuts.
5-2 Position the round center component over the remaining
exposed studs at the center and attach using washers and cap
nuts. Tighten securely.
STEP 6
threaded bolts located on the top of the head unit.
secure with wing nuts.
**IMPORTANT NOTICE**
Establishing a burner ignition for the FIRST time or after changing the cylin-
der tank may take up to 2-3 minutes in order for the gas to purge through
the feeder lines.
** IMPORTANT NOTICE***
Do NOT return to place of purchase!!!
Please contact our Toll Free Hotline: 1 (866) 765.0710
for customer service and warranty issues
e-mail: customercare@jrhome.com
Hotline hours: Mon. to Fri. 7:00am - 5:00pm ( P.S.T.)
All manuals and user guides at all-guides.com
ASSEMBLY INSTRUCTIONS - 8
4-1
4-2
5-1
5-2