steel E9F5FINF Manuel D'utilisation page 93

Instructions for the user
Confirm the programme by pressing the push knob (minimum programming time: 1 minute of
cooking).
An audible alarm will automatically activate.
•
The oven will switch on immediately and switch off automatically when the set cooking end
time coincides with the current time.
To display the set programme, press and release the push knob (the hands and the LEDs will
display the set programme).
At the end of cooking, the
•
push knob to deactivate it).
To cancel the programme before the end of cooking, press the push knob for 3 seconds; the
programme will be cancelled and the electronic clock will return to manual cooking mode.
PROGRAMMING COOKING START AND END TIMES
Programming the cooking start time enables cooking to start and end automatically based
on the programme.
To programme the cooking start time, proceed as follows:
press the push knob once until the
•
turn the push knob clockwise or anticlockwise to increase or decrease the cooking start time;
•
the minutes hand moves in 1-minute stages clockwise or anticlockwise. The
keep flashing for 10 seconds after last turning the push knob.
If the push knob is not turned or pressed within 10 seconds, the hands will automatically return
to the current time and the programme will be cancelled.
On pressing the push knob, the cooking start time will be stored (
•
steady) provided at least 1 minute's delay has been programmed and the cooking end
time* is now set (
The oven will switch on automatically when the set cooking start time coincides with the
current time.
*To programme the cooking end time, follow the procedure given in the previous section
on p. 92.
LED will flash and the alarm sounds for 1 minute (press the
LED flashes;
LED will go from off to flashing).
LED will
LED on and
93