Booster Function; Residual Heat - steel E9F5FINF Manuel D'utilisation

Instructions for the user
7.6.2 Rapid heating function
This function enables the required power level to be reached more quickly,
although it remains active for a very limited period of time.
Starting from "0" position, turn the knob anticlockwise until it clicks and hold
it in that position for 2 seconds; the display will light up showing the adjacent
symbol. You will then have 10 seconds to turn the knob to the required power
level; the display will start flashing alternating symbol
level set with the knob.
The following table gives the rapid heating times to the various power levels.
SELECTED POWER LEVEL
DURATION IN SECONDS
7.6.3

Booster function

Turn the knob clockwise beyond power level "9" until you hear a click and
an audible signal (the display shows the adjacent symbol); then reposition
the knob on level "9".
The knob must be correctly repositioned on level "9"; otherwise the symbol
, shown on the display, will be replaced by error code
deactivation of the radiant element; to restore the radiant element, follow the
instructions given in paragraph " 7.6.7".
The maximum heating time with the Booster function is 10 minutes.
At the end of the maximum heating time, symbol
and the power is automatically reset, displaying the value .
With the Booster function activated, several consecutive cycles can be repeated.
7.6.4

Residual heat

After cooking is finished and the knob is returned to "0" position, the radiant element's display
shows the adjacent symbol alternated with the value , indicating that that radiant element has just
been used and is still hot.
The symbol will flash for a few seconds, then will become steady and will stay on until the
glass temperature has gone below the safety level.
7.6.5 Ventilation
The cooling system is fully automatic. The cooling fan starts with a low speed when the calories
brought out by the electronic system reach a certain level. The ventilation starts his high speed
when the hob is intensively used. The cooling fan reduces his speed and stops automatically
when the electronic circuit is cooled enough.
7.6.6 Overheating
The induction hob is fitted with a safety device that protects the internal electronics against
overheating. This device requires no attention from the user and enables the hob to be used
confidently without the risk of overheating.
1 2 3
48 144 230 312
flashes for a few seconds
with the new power
4 5 6
408 120 168
which signals
7 8 9
216 -
101